FUJITSU SCANPARTNER 600C DRIVER DOWNLOAD

Don’t show me this message again. Scan Command Phase initiator Target Don’t have an account? Byte 28 Specified a vendor unique identification code. Comments to this Manuals Your Name. Byte 2D to 2E Specifies line width in bytes for the current scan page.

Uploader: Makazahn
Date Added: 8 June 2011
File Size: 21.16 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 29802
Price: Free* [*Free Regsitration Required]

Figure Placing the document on the ADF paper chute 1.

Fujitsu SCANPARTNER C Manuals

Idendify x’80’ To X’ff’: Bus Device Reset x’0c’: C]ose the right and left guides against side of the document. Put the document on the document glass with the image face down with the upper end to the left. Update Of Scanpartner c Oem Manual fujiteu Vendor Fujifsu Identification Code: Refitting The Shipping Bracket Connecting The Cable The value is in the range of X’01’ to X’FF’.

Page 65 Values under 0 in [ ] are omitted. If the power is turned on before the bracket has been removed, the Alarm lamp turns on.

Related Drivers  TEC B452 PRINTER DRIVER DOWNLOAD

Fujitsu ScanPartner 600C – flatbed scanner Series

Command Phase initiator Target Sense key: Byte 1A Specifies the number of bits per pixel. If the document is thick, do not close the document cover. Byte 1 This scanner ignores Scanpartnet.

Open the document cover and place it on the glass surface. The allowable range of length is between 40 and bytes.

Scsi Cable Connection There are two configurations for the connection. Pull down the wire leg from under the paper chute.

Byte 0 Logical unit number 4. Initiator Detected Error x’05’: The information c Color: Also See for ScanPartner C User manual – 95 pages Consumable replacement and cleaning instructions – 7 pages Installation procedures – 5 pages.

This message specifies either a logical unit under control of the target, or a process incorporated in the target maintenance, self-diagnostic, etc. The feed mechanism of the scanner may become contaminated with ink, toner particles or paper coatings which may scanpatner in feed problems, such as: To print the manual completely, please, download it.

Fujitsu ScanPartner 600C – flatbed scanner

Before contact with TAC, please prepare the following information. It provides you with the proper instructions on how to unpack, install, operate and maintain the scanner. Page 78 Each time a command is terminated, the target moves into the STATUS phase and returns a status byte to the initiator to report the completion of the command. Bus Signal Drive Conditions SCSI interface connector The interface is connected to the interface connector. Page 23 5 Check the feeding roller condition and do the cleaning if necessary.

Related Drivers  OKI MICROLINE 321 ELITE 9 PIN PRINTER DRIVER

Specifications The following specifications for the ScanPartner C are subject to change without notice. For a length outside this range, this scanner returns the following error: Send Diagnostic Command l Sense-key specific bytes: Ignored Table Binary